Dell PowerVault MD3620i Panduan Instalasi - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penyimpanan Dell PowerVault MD3620i. Dell PowerVault MD3620i 18 halaman. Dell powervault modular disk storage arrays
Juga untuk Dell PowerVault MD3620i: Matriks Dukungan (11 halaman)
Halaman Cetak
Managing the SMI-S Provider
Starting and Stopping the OpenPegasus CIM Server
Windows-Based Operating Systems
To start or stop the OpenPegasus CIM server:
•
Open the Services window and locate the cimserver service. Right-click
cimserver service and select start or stop.
Or
•
In the command prompt type:
net start cimserver to start a service
net stop cimserver to stop a service
Linux-Based Operating Systems
To start or stop the OpenPegasus CIM server, on a terminal window type:
cimserver to start a service
cimserver -s to stop a service
Adding or Removing a Storage Array From the
SMI-S Provider
During installation, you are prompted to enter the IP addresses into a file.
After this initial setup, the SMI-enabled client must use the SMI-S Provider
proxy server system management profile to add or remove devices.
NOTE:
When a storage array is added, the IP address of only one of the
management ports of the storage array must be supplied (and not both
management ports). Entering the IP addresses for both management ports of a
single storage array causes unpredictable behavior of the SMI-S Provider.
Managing the SMI-S Provider
3
15