Ensy AHU Series Prosedur Startup - Halaman 2

Jelajahi secara online atau unduh pdf Prosedur Startup untuk Kipas angin Ensy AHU Series. Ensy AHU Series 8 halaman.

393803‐2 Startup procedure for EnSy AHU units

Information can be found on the data plaque inside the unit. This sign shows. AHU‐400 BH

Unit type: AHU‐_____________

Serial no: 010_________ _____. ____ / _____

Date of

start up

first

time: ___________

Where the unit is installed:

Name: ____________________________________________________

Address: __________________________________________________

Here are some points to be checked after Ensy® AHU unit is

installed.

1. Insert the plug into a grounded socket.

Then you will have a picture like this in display.

(Time and temperatures will show other values then shown here)

2. Control to see if there are contact between Display and Master

software in unit.

Press control button 3 once to get into the information menu.

Press control button 3 once to get into the Program version menu.

Press (Enter) control button 4.

You than will see that there are contact with Display and Mastercard software in menu picture (3.2).

Press control button 1 (Return) twice to get back to start up menu.

Note! If you have installed an extra display then you have to program one of the displays with

name Display 2. (Both displays must have same software version.)

Press control button 4 once to get into 4. Preferences.

Press control button 3 four times to get to Setup.

Press (Enter) control button 4 to get into 4.5 PIN code.

We reserve the right to change technical data without notice http://www.ensy.no

REV:0_08.09.2016. KJK

Controll button 1.

Overview push buttons.

Latest display

software are 021 and

Master are 034.

Fill in three last numbers:

Display 1 Ver: _________

Display 2 Ver: _________

Master Ver: ___________

Page 2