Dell EMC Edge 510 LTE Panduan Instalasi - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih Dell EMC Edge 510 LTE. Dell EMC Edge 510 LTE 24 halaman. Networking switch
Juga untuk Dell EMC Edge 510 LTE: Setup Manual (8 halaman)
Halaman Cetak
To install the Edge 510 LTE platform, complete the installation procedures in the order that is in this chapter.
Always handle the platform and components with care.
NOTE:
For thermal considerations, do not stack the Edge 510 LTE platforms on top of each other.
NOTE:
If components are mishandled, ESD damage can occur. Always wear an ESD-preventive wrist or heel ground strap
when handling the platform and components. As with all electrical devices of this type, take all the necessary safety
precautions to prevent injury when installing this platform.
Topics:
•
Unpack
•
SIM card
•
Desktop mount
•
Wall mount
•
Rack mount
•
Platform power-on
•
Platform setup
•
Configure Edge 510 LTE activation
Unpack
NOTE:
Before unpacking the platform, inspect the container and immediately report any evidence of damage.
When unpacking the platform, ensure that the following items are included:
● AC power cable
NOTE:
Power cable is in a separate box from the unit.
● Two RJ45 cables
● One Dell EMC Edge 510 LTE platform
● Two antennas
● AC-to-DC power adapter
● Wall mount brackets
● Dell EMC Edge 510 LTE Set Up Guide
● Safety and Regulatory Information
● Warranty and Support Information
1. Place the container on a clean, flat surface and cut all straps securing the container.
2. Open the container or remove the container top.
3. Carefully remove the appliance from the container and place it on a secure and clean surface.
4. Remove all packing material.
5. Inspect the product and accessories for damage.
SIM card
Remove the small Philips screw on the door for SIM access. Two SIM slots are available. However, only use the lower SIM slot
and insert the SIM card with the contacts facing up until it clicks into place.
10
Edge 510 LTE installation
Edge 510 LTE installation
4