Dell Force10 C150 Panduan Memulai Cepat - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Beralih Dell Force10 C150. Dell Force10 C150 33 halaman. Quick start guide

Installing the Hardware

This guide assumes all site preparation has been performed before installing the

chassis.

Installing the Chassis

To install the C150/300 chassis, Dell Force10 recommends that you complete

the installation procedures in the order presented below.

NOTE: Unless stated otherwise, the installation instructions below apply to both

the C150 and C300 chassis.

Always handle the system and its components with care. Avoid dropping the

switch or its field replaceable units.

CAUTION: Always wear an ESD-preventive wrist or heel ground strap when

handling the chassis and its components. As with all electrical devices of this

type, take all necessary safety precautions to prevent injury when installing

this system. Electrostatic discharge (ESD) damage can occur if components

are mishandled.

WARNING: Use an equipment lift or pallet jack when lifting or moving the

chassis. Install the chassis into the rack before inserting chassis components.

Lift the C150/300 chassis only from the bottom. Lifting by the chassis shelves

or power supply openings might damage the chassis.

WARNING: To prevent bodily injury when mounting or servicing this unit in

a rack, you must take special precautions to ensure that the system remains

stable. The following guidelines are provided to ensure your safety:

•

This unit should be mounted at the bottom of the rack if it is the only unit

in the rack.

•

When mounting this unit in a partially filled rack, load the rack from the

bottom to the top with the heaviest component at the bottom of the rack.

•

If the rack is provided with stabilizing devices, install the stabilizers

before mounting or servicing the unit in the rack.

Follow these steps to install the chassis into a 19-inch equipment rack:

Installing the Hardware