Dell Force10 S4810P Panduan Memulai Cepat - Halaman 21

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Beralih Dell Force10 S4810P. Dell Force10 S4810P 27 halaman. Quick start guide

Configure the Enable Password

Access the EXEC Privilege mode using the enable command. The EXEC

Privilege mode is unrestricted by default. Configure a password as a basic

security measure. There are two types of enable passwords:

•

enable password stores the password in the running/startup configuration

using a DES encryption method.

•

enable secret is stored in the running/startup configuration in using a

stronger, MD5 encryption method.

Dell Force10 recommends using the enable secret password.

Task

Create a password to

access EXEC

Privilege mode.

The Default VLAN as VLAN 1 is part of the system startup configuration and

does not require configuration. To configure a port-based VLAN, you must

create the VLAN and then add physical interfaces or port channel (LAG)

interfaces to the VLAN.

Task

Configure a port-based VLAN (if the

vlan-id is different from the Default

VLAN ID) and enter INTERFACE

VLAN mode. After you create a

VLAN, you must assign interfaces in

Layer 2 mode to the VLAN to activate

the VLAN.

Use the show vlan command in the EXEC Privilege mode to view the

configured VLANs.

Command Syntax

enable [password | secret] [level level]

[encryption-type] password

Command Syntax

interface vlan vlan-id

Command Mode

CONFIGURATION

Command Mode

CONFIGURATION

Installing the Software