Dell Force10 Z9000 Panduan Memulai Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Beralih Dell Force10 Z9000. Dell Force10 Z9000 25 halaman. Dell force10 z9000 system quick start guide

Halaman Cetak
Step
Task
Attach the brackets to the sides of the chassis on either side, using four
2
screws for each bracket.
Attach the bracket so that the "ear" faces to the outside of the chassis.
Install chassis into rack or cabinet
Step
Task
Dell Force10 recommends that one person hold the Z9000 chassis in
1
place while a second person attaches the brackets to the posts.
Attach the bracket "ears" to the rack or cabinet posts, using two screws
2
for each bracket. Ensure the screws are tightened firmly. The example
here shows the mounting on the I/O side, but either side can be used.
View from I/O side
Attach a Ground Cable
Use a single M4x0.7 screw for attaching a ground cable to the chassis. The cable
itself is not included. Dell Force10 recommends a 6AWG one-hole lug, #10 hole
size, 63" spacing (not included in shipping) to properly ground the chassis. The
one-hole lug must be a UL recognized, crimp-type lug.
NOTE: The rack installation ears are not suitable for grounding.
CAUTION: Grounding conductors must be made of copper. Do not use
aluminum conductors.
6
Installing the Hardware
I/O side
Rack/Cabinet
Mounting Ears
View from PSU side
Connect to
rack/cabinet
(ears)
Rack/Cabinet
Post
Connect to
rack/cabinet
(ears)
Screws