Allied Telesis AT-AR021 BRI-U Panduan Instalasi dan Keselamatan - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Keselamatan untuk Kartu Jaringan Allied Telesis AT-AR021 BRI-U. Allied Telesis AT-AR021 BRI-U 8 halaman. Port interface card
Juga untuk Allied Telesis AT-AR021 BRI-U: Panduan Instalasi (13 halaman), Panduan Instalasi (13 halaman)
Halaman Cetak
6
9. Slide the PIC into place.
PIC bays should be filled in numerical order, starting with the lowest available
bay (e.g., bay 0) followed by bays with progressively higher numbers.
10. Secure the PIC by tightening its thumbscrews.
11. Apply power to the switch or router.
Re-attach the power cord, and reconnect any redundant power supply.
12. Test the PIC.
There are several ways to check the PIC is installed and functioning correctly.
The show system command displays general system information about PICs
and any other hardware installed, as well as memory, software version and
patches loaded on the switch or router.
See the Port Interface Card Hardware Reference for detailed information on PIC
testing.
Setting the ISDN Territory
You must change the default ISDN territory to your region before you connect an
ISDN PIC to your Telecommunications Network. Use the command:
set system territory={australia|china|europe|japan
|korea|newzealand|usa}
In Australia only:
To use the Micro service, set the territory to australia.
■
To use the OnRamp service, set the territory to europe.
■
See the Software Reference provided with your switch or router for further
information on configuring ISDN.
613-000601 Rev A
Port Interface Card