Dell PowerConnect M8024 Panduan Konfigurasi - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Beralih Dell PowerConnect M8024. Dell PowerConnect M8024 21 halaman. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Juga untuk Dell PowerConnect M8024: Catatan Rilis (9 halaman), Catatan Rilis (27 halaman), Meningkatkan Firmware (24 halaman)

Dell PowerConnect M8024 Panduan Konfigurasi
4.3

Configure virtual stack ports (switch 1)

console(config)#stack
console(config-stack)#stack-port tengigabitethernet 1/0/21 stack
console(config-stack)#stack-port tengigabitethernet 1/0/22 stack
console(config-stack)#stack-port tengigabitethernet 1/0/23 stack
console(config-stack)#stack-port tengigabitethernet 1/0/24 stack
console(config-stack)#exit
console(config)#exit
4.4

Save configuration

console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
4.5

Prepare the first switch for stack membership:

console>enable
(Provide the enable password you set previously)
console#config
console(config)#stack
console(config-stack)#member 2 2
console(config-stack)#exit
console(config)#exit
console#copy running-config startup-config
4.6

Configure virtual stack ports (switch 2)

On the second switch only, enter the following:
console#configure
console(config)#switch 1 renumber 2
All the switches in the stack will be reset to perform Manager unit renumbering and the configuration of
Manager switch interfaces will be cleared.
Are you sure you want to renumber? (y/n)y
16
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs