Dell PowerEdge M520 Manual - Halaman 18

Jelajahi secara online atau unduh pdf Manual untuk Beralih Dell PowerEdge M520. Dell PowerEdge M520 25 halaman. Dell poweredge blade servers getting started guide
Juga untuk Dell PowerEdge M520: Pembaruan Informasi (38 halaman), Catatan Rilis (27 halaman), Panduan Pengguna (23 halaman), Panduan Informasi Penting (35 halaman), Manual Pembaruan (32 halaman), Manual Pembaruan (28 halaman), Panduan Pengguna (26 halaman), Panduan Pengguna (22 halaman), Panduan Memulai (12 halaman), Panduan Teknis (46 halaman), Panduan Teknis (45 halaman), Panduan Portofolio (27 halaman), Panduan Memulai (14 halaman), Panduan Memulai (12 halaman)

Rev 1.00

3.7

Port Commands

Synopsys:

set port test port_number [prbs31 on|off|start|stop]

Description:

Configure test mode on a port. Test mode is used to measure link quality and calibrate link tuning parame-

ters.

• port_number: downlink port number on which to enable / disable test mode

• prbs31: industry-standard pseudo-random binary sequence for link tuning

- prbs31 on: move the port to test mode

- prbs31 start: initalize prbs31 mechanism and start error counting

- prbs31 stop: terminate prbs31 error counting

- prbs31 off: move the port back to operational mode

After "prbs31 on" and before "prbs31 start", configure prbs31 on the remote peer.

Note:

Example:

& set port test 6 prbs31 on

& # enable prbs31 on remote peer now

& set port test 6 prbs31 start

& show port test 6

port 6 prbs31 on: 0 errors

& set port test 6 prbs31 stop

& set port test 6 prbs31 off

Synopsys:

show port link [port_number]

Description:

This command displays detailed port information. If an uplink port number is specified

([port_number]), then the command displays information only for this port; otherwise, the com-

mand displays information for all the ports.

The command displays the following information per port:

• Port number

• Port group identifier and speed: A, B, followed by the configured speed (10G)

• Pass through connection status, may have one of the following values:

down - either uplink or downlink is not connected

Software User's Manual