Dell PowerSwitch S4128T-ON Panduan Instalasi - Halaman 21

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih Dell PowerSwitch S4128T-ON. Dell PowerSwitch S4128T-ON 49 halaman.

The cabinet must meet minimum size requirements. Airflow must be in accordance with the Electronic Industries Alliance (EIA)

standard. Ensure that there is a minimum of 5 inches (12.7 cm) between the intake and exhaust vents and the cabinet wall.

Rack mounting

When you prepare your equipment rack, ensure that the rack is grounded. Ground the equipment rack to the same ground point

the power service in your area uses. The ground path must be permanent.

Dell Technologies recommends grounding your switch. Use the S4100–ON Series switch in a CBN.

NOTE:

For AC-powered switches, although the third conductor of the AC power cable provides a ground path, Dell

Technologies recommends grounding your switch with a dedicated ground wire.

NOTE:

For DC-powered switches, the only way to safely ground your switch is to attach a dedicated ground wire.

The fans on the S4100–ON Series (S4128F-ON, S4148F-ON, S4148FE-ON, S4128T-ON, S4148T-ON, and S4148U-ON) support

two airflow options: normal and reverse.

Fan combinations

Fan installation is done as part of the factory install based on SKU type. The S4100–ON Series has stock keeping units (SKUs)

that support the following configurations:

● AC PSU with fan airflow from the I/O to the PSU—normal

● AC PSU with fan airflow from the PSU to the I/O—reverse

● DC fan unit with airflow from the I/O to the PSU—normal

● DC fan unit with airflow from the PSU to the I/O—reverse

Be sure to order the fans suitable to support your site's ventilation. Use a single type of airflow fan in your switch. Do not mix

reverse and normal airflows in a single switch.

For proper ventilation, position the S4100–ON Series switch in an equipment rack or cabinet with a minimum of 5 inches (12.7

cm) of clearance around the exhaust vents. The fan speed varies based on internal temperature monitoring. The switch never

intentionally turns off the fans.

For more information, see Fans.

Connect the switch to the applicable power source using the appropriate power cable. An AC power cable is included with each

PSU.

When installing AC or DC switches, follow the requirements of the National Electrical Code ANSI/NFPA 70, where applicable.

The switch is powered-up when the power cable is connected between the switch and the power source.

For more information, see

CAUTION:

Always disconnect the power cable before you service the power supply slots. The switch has

multiple power cords. Before servicing, ensure all power cords are disconnected.

CAUTION:

On the AC switch, use the power supply cable as the main disconnect device. Ensure that the

socket-outlet is located/installed near the equipment and is easily accessible.

Power

supplies.

Site preparations