Dell S4048-ON Panduan Konfigurasi - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Beralih Dell S4048-ON. Dell S4048-ON 30 halaman. Enterprise switches
Juga untuk Dell S4048-ON: Panduan Konfigurasi (19 halaman), Panduan Pemecahan Masalah (29 halaman)

Halaman Cetak

Switch configuration (OS 9.x)

2.4.4

Configure stack on the second switch

Dell>enable

Dell#stack-unit 1 renumber 2

Note: After confirming the configuration change, the switch will need to reboot.

Dell#configure

Dell(conf)#stack-unit 2 priority 1

Dell(conf)#stack-unit 2 stack-group 12

Dell(conf)#stack-unit 2 stack-group 13

Dell(conf)#exit

Dell#copy running-config startup-config

Dell#reload

2.4.5

Verify stack configuration

From the first switch (master) CLI, confirm that the stack has formed.

Dell#show redundancy

Dell#show boot system stack-unit all

Note: The MASTER LED on the switch front panel will show a steady light for the master unit and a blinking

light for the standby unit. All of the following configuration steps must be performed from the master switch.

2.4.6

Configure out of band (OOB) management port

Dell#config

Dell(conf)#interface ManagementEthernet 1/1

Dell(conf-if-ma-1/1)#no shutdown

Dell(conf-if-ma-1/1)#ip address <ipaddress> <mask>

Dell(conf-if-ma-1/1)#no shutdown

Dell(conf-if-ma-1/1)#exit

2.4.7

Configure route for OOB management port (optional)

Dell(conf)#management route <X.Y.Z.0> /24 <A.B.C.1>

Note: In the previous command, <X.Y.Z.0> is the network your management system is connecting from and

<A.B.C.1> is the gateway for the switch. If your management system is on the same subnet as the switch, the

previous step may be omitted. The prior example assumes a class C subnet mask.

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026