Dell S4048-ON Panduan Konfigurasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Beralih Dell S4048-ON. Dell S4048-ON 30 halaman. Enterprise switches
Juga untuk Dell S4048-ON: Panduan Konfigurasi (19 halaman), Panduan Pemecahan Masalah (29 halaman)

Halaman Cetak

Switch configuration (OS 9.x)

2.1.2

Delete startup configuration

Note: The following commands will delete all configuration settings.

Dell>enable

Dell#delete startup-config

Proceed to delete startup-config [confirm yes/no]yes

Dell#reload

System configuration has been modified. Save? [yes/no]no

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

2.1.3

Configure out of band (OOB) management port

Dell>enable

After the startup configuration is deleted, the factory default enable mode password is calvin.

Dell>#configure

Dell(conf)#interface ManagementEthernet 1/1

Dell(conf-if-ma-1/1)#no shutdown

Dell(conf-if-ma-1/1)#ip address <ipaddress> <mask>

Dell(conf-if-ma-1/1)#exit

2.1.4

Configure route for OOB management port (optional)

Dell(conf)#management route <X.Y.Z.0> /24 <A.B.C.1>

Note: In the previous command, <X.Y.Z.0> is the network your management system is connecting from and

<A.B.C.1> is the gateway for the switch. If your management system is on the same subnet as the switch, the

previous step may be omitted. The prior example assumes a class C subnet mask.

2.1.5

Configure login credentials

Dell(conf)#username admin privilege 15 password 0 <yourpassword>

Dell(conf)#enable password level 15 0 <yourpassword>

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026