Dell S60 System Manual - Halaman 28
Jelajahi secara online atau unduh pdf Manual untuk Beralih Dell S60 System. Dell S60 System 45 halaman.
Halaman Cetak
Access the Console Ports
You can access the S60 system directly through the console port at rear of the system
Access the RJ-45 Console Port (RS-232)
NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on
your PC.
The RS-232 console port is labeled on the upper right-hand side on the rear of the S60 system.
Figure 6-1. S60 Serial Console Port Connector
For the console port pin assignments, refer to
To access the RJ-45 console port, follow these steps:.
Step
Task
Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S60 console port to a
1
terminal server.
Connect the other end of the cable to the DTE terminal server.
2
Set the default terminal settings as follows:
3
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
Console
Port
Table
6-1.
6
(Figure
6-1).
Access the Console Ports
|
28