Dell 5530 Mono Laser Panduan Servis - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Servis untuk Printer Dell 5530 Mono Laser. Dell 5530 Mono Laser 46 halaman. Loading paper and specialty media
Juga untuk Dell 5530 Mono Laser: Panduan Referensi Cepat (2 halaman), Manual Pengaturan Dan Spesifikasi (29 halaman), Pengaturan dan Spesifikasi (29 halaman)
Halaman Cetak
Installing the Base Cover
1
Place the base cover on the computer and snap it in place.
2
Tighten the M2x3 T5 (10), M2x8 (2) screws to secure the base cover to the computer.
NOTE:
Ensure you use a Torx #5 screwdriver for the base screws and a Philips screwdriver for the two M2x8 system badge
screws.
3
Turn the system badge flap over and snap it in place.
4
Follow the procedures in
Battery
Removing the Battery
NOTE:
Discharge the battery as much as possible before removing from the system. This can be done by disconnecting the A/C
adapter from the system (while the system is turned on) to allow the system to drain the battery.
NOTE:
System shipped with 3-Cell battery has 4 screws, the hard drive will be part of the configuration (Optional).
1
Follow the procedures in
2
Remove the
base cover
3
Perform the following steps to remove the battery:
a
Disconnect the battery cable from the system board [1].
b Remove the M2x4 (7) screws that secure the battery to the computer [2].
c
Lift the battery off the computer [3].
•
Do not apply pressure to the surface of the battery
•
Do not bend
•
Do not use tools of any kind to pry on or against the battery
•
If a battery cannot be removed within the constraints above, please contact Dell technical support
After Working Inside Your
Computer.
Before Working Inside Your
Computer.
Disassembly and reassembly
13