DHK Hobby Optimus Panduan Instruksi Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Instruksi Pengguna untuk Mobil Mainan Bermotor DHK Hobby Optimus. DHK Hobby Optimus 20 halaman. 1/8 scale 4wd brushless electric buggy
Halaman Cetak
9kgs Servo
Note:
When the motor temperature is over 120˚C(248˚F), please add a fan over the motor for better
ventilation. Please refer to the parts list for the optional part motor cooling fan (Part#: P101).
Lipo Batteries
This model comes with single 11.1V 3200mAh Lipo battery pack. Handling Lipo batteries should be very
careful. Please read the following points with regard to charging and discharging Lipo batteries.
Charging the Lipo battery
Important warnings:
Be sure to follow these important warnings regarding the charging of Lipo batteries.
> Never leave a Lipo battery unattended at any time while being charged.
> Never charge a Lipo battery while it's inside the model. A hot pack could ignite wood, foam, plastic,
etc.
> Never charge Lipo battery with Ni-Mh or Ni-Cd peak charger. Only use a charger designed specifically
for Lipo batteries which can apply the constant current/constant voltage charge technique.
> Never charge Lipo battery at currents greater than the "1C" rating of the battery.
> Never allow Lipo cells to overheat at any time. Cells which exceed 60˚C (140˚F) during charge can
and usually will become damaged physically and possibly catch fire. Always inspect a battery which has
previously overheated and do not re-use if you suspect it has been damaged in any way.
> Always discontinue charging a Lipo immediately if at any time you witness smoke or see the battery
starting to swell up. This may cause the battery to rupture and/or lead, and the reaction with air may
cause the chemicals to ignite, resulting in fire. Disconnect the battery and leave it in a safe fireproof
location for approximately 15 minutes.
> Always charge a Lipo battery in a fireproof location, which could be a container made of metal,
ceramic tile, or a bucket of sand.
> Never allow a battery's positive and negative leads to accidentally touch each other. This will result in
a short circuit and cause permanent damage to your battery and charger.
> Always monitor the battery and charger during the entire charge process. Never leave the battery and
charger unattended during charge!
> Never continue to charge the Lipo batteries if the charger fails to recognize full charge. Overheating or
swelling of the Lipo cells is an indication that a problem exists and the batteries should be disconnected
from the charger immediately and placed in a fireproof location.
Discharging the Lipo battery
> Never leave a Lipo battery unattended at any time while being discharged.
> Always discharge Lipo batteries in a fireproof location, which could be a container made of metal or
on ceramic tile.
> Always connect the battery's lead marked "Discharge" or "TO ESC" to the electronic speed controller.
Never attempt to connect the battery's "CHARGE" lead to the ESC.
Features
Working voltage
Speed (seconds/60˚C)
Torque
Net weight
Size(LxWxH)
: Metal gears, ball bearings
: 6.0V
: 0.16sec
: 9kg/cm (88.3Ncm)
: 60g
: 55x21x43mm
3