3 Legged thing Legends Jay Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Aksesori Kamera 3 Legged thing Legends Jay. 3 Legged thing Legends Jay 9 halaman.

Legs, catches & locks

In order to change the leg angle you will need to press down on

the Rapid Latch leg catch (a) manoeuvre the leg into the desired

position and then release the catch. You don't need to press the

Rapid Latch to stow your tripod.

To open and extend the tripod legs simply grip the twist locks in your

hand, quarter turn (clockwise as you look down on it), loosening

the legs allowing you to select a desired height. Once the required

height has been obtained, lock the legs in place by rotating back

anti-clockwise to the original position, which will fully engage the

leg lock. The friction locks do not require to be undone further than

a half turn, unless you intend to completely disassemble the legs

for cleaning.

Detachable Legs

All three legs can be unscrewed directly from the leg hinge

(a) and used as monopods or boom arms.

The levelling base canopy can be converted to a table-

top tripod by removing the legs and screw Vanz* or

Stillettoz* (d) into the leg hinges (a). To position the legs, use

the Rapid Latch (c) to adjust. Mount your camera directly

on to the levelling base using the 1/4"-20 thread, or add an

AirHed using the supplied 3/8"-16 adapter.

To convert to a monopod with a foot stabiliser, unscrew all

3 detachable legs (b) from the leg hinges. Screw Vanz* or

Stillettoz* (d) into the leg hinges and using the Rapid Latch,

position the legs to the desired angle (e). Remove the 3/8-

16" mount sleeve from the bottom of the detached leg

using your Toolz to loosen it out and screw the detached

leg onto the 1/4"-20 and 3/8"-16 thread mount until its

secure.

Screw your AirHed onto the top of the leg to create your

monopod head. Once your monopod is all set up loosen

the friction lock / d-ring to release the base to create fluid

movement. Adjust the friction lock to create your desired

level of drag. The tighter the friction lock / d-ring is, the

more drag will occur. To stop all movement, tighten both

the friction lock and pan lock being cautious not to over

tighten. (Over tightening may make it difficult to undo the

locks once you have finished using it).

*Footwear sold separately

Warning - do not angle the monopod beyond the

boundaries of the levelling base as you may damage the

leg or levelling base.

Do not let go of your camera when mounted on to any

monopod setup.