32 Degrees Icon-E Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan paintball 32 Degrees Icon-E. 32 Degrees Icon-E 6 halaman.

11. Unscrew the propellant cylinder approximately one complete revolution.

12. Pull the trigger until the marker fails to re-cock (if this takes more than 10 shots,

unscrew the cylinder an additional turn and repeat).

13. Remove (See Warning Above) the propellant cylinder.

Maintenance

WARNING: All maintenance should be performed with an unloaded and degassed

marker ONLY.

Bolt and Hammer

1. De-gas the marker according to previous directions.

2. Always perform maintenance over a smooth, clean work surface. This will help

prevent the accidental loss of small parts.

3. Make sure the bolt is in the forward position before proceeding.

4. Remove the Quick Strip Pin (#5).

5. Remove the Hammer Plug (#24) from the rear of the Main Body.

6. Pull the Bolt (#28) from the rear. This will also remove the Spring Strut (#4), Main

Spring (#2), Recoil Pad (#3), and Hammer (#1).

7. Clean the Bolt thoroughly; this includes rinsing in warm water if needed. Be sure to

dry all parts well before the next step.

8. Lubricate the Bolt and Hammer with non-corrosive lubricant such as Empire Lube or

Empire Oil.

9. While pointing the marker downward, place the Bolt's Connecting Pin (#28A) into the

hole on top of the Hammer. Guide this assembly in to the rear of the Main Body.

10. The Striker will likely stop when it makes contact with the top of the Sear (#37).

11. Push the "Safety" to the on position; this should light the LED on the circuit board to

signify it is on.

12. While putting slight pressure on the rear of the bolt, pull the trigger (this depresses

the Sear and allows the Bolt/Hammer assembly to travel forward).

13. Push the "Safety" to the OFF position and the LED on the circuit board should shut off.

14. Return the Main Spring, Recoil Pad, and Spring Strut to their proper position follow-

ing the schematic on Page (5).

15. Place the Hammer Plug into the rear of the Main Body with the longest portion of

the Main Spring / Spring Strut.

16. Push the Hammer Plug in and replace the Quick Strip Pin.

Storage

Always turn off the marker and remove the hopper/feeder, all paintballs and propellant

source and place it in a secure location where it cannot be accessed by unauthorized

persons.