EarthQuake 9800BCE Panduan Operator - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Operator untuk Peralatan Rumput dan Taman EarthQuake 9800BCE. EarthQuake 9800BCE 19 halaman. Two-man earth auger powerhead
Juga untuk EarthQuake 9800BCE: Panduan Operator (20 halaman)

Halaman Cetak
Earthquake
Operator's Manual
Two-Man Earth Auger Powerhead 9800 Series
Clean debris from area around the gas cap.
Loosen gas cap slowly. Place the cap on a clean, dry surface.
Carefully add fuel without spilling.
Do notfill gastankcompletelyfull; allow spacefor fueltoexpand.
Immediately replace gas cap and tighten.Wipe off spilled fuel
and allow to dry before starting engine.
IMPORTANT OPERATION NOTES
Read engine manual and follow instructions for fuel type,
starting, etc.
The clutch will transfer maximum power after about two
hours of normal operation. During this break-in period clutch
slippage may occur. The clutch should be kept free of oil or
other moisture for efficient operation.
The earth auger unit should be operated no more than 20
degrees many direction during continuous use, and limited to
30 degrees intermittently. This is recommended for adequate
lubrication and fuel delivery.
When digging in heavy soil, lift the earth auger unit out of
the hole once for every one foot of depth.
Never run engine indoors. Exhaust fumes are deadly.
Do not use an earth auger in ice.
Drill holes without placing excessive body weight on the unit.
The auger operates most efficiently with a shaving action
caused by the weight of the unit itself.
STARTING AND STOPPING ENGINE
TO START ENGINE:
Check the engine oil level.
Make sure engine drive controls, if equip are disengaged.
Open fuel shut-off valve.
Flip the on/off switch to ON position.
Move choke lever to the CHOKE position.
NOTE: Do not use the choke to restart a warm engine after
a short shut down.
Grasp starter handle and pull rope out slowly, until it pulls
slightly harder. Then pull rope with a rapid full arm stroke.
Let rope return to starter slowly.
When engine fires or starts running, gradually move the choke
lever back to the RUN position.
TO STOP ENGINE:
Flip the on/off switch to the OFF position.
Close fuel shut-off valve.
A
WARNING
MAKE SURE THE UNIT IS IN A STABLE POSITION
BEFORE PULLING THE STARTER HANDLE.
WHEN THE UNIT STARTS TO FIRE OR RUN, RELEASE
THE THROTTLE CONTROL MOMENTARILY WITH YOUR
RIGHT HAND AND RETURN YOUR LEFT HAND TO THE
HANDLEBAR POSITION TO MAINTAIN CONTROL AND
STABILITY OF THE UNIT WITH BOTH HANDS.
A
CAUTION
ALWAYS HANDLE FUEL IN A WELL VENTILATED AREA,
OUTDOORS, AWAY FROM FLAMES OR SPARKS.
DO NOT START ENGINE IF FUEL IS SPILLED. WIPE OFF
EXCESS FUEL AND ALLOW TO DRY. REMOVE ENGINE
FROM AREA TO AVOID SPARKS.
TO PREVENT ACCIDENTAL STARTING; ENGINE MUST BE
TURNED OFF AND COOL, AND SPARK PLUG WIRE MUST
BE REMOVED FROM SPARK PLUG BEFORE CHECKING
AND ADJUSTING ENGINE OR EQUIPMENT.
DO NOT OPERATE AUGER BEFORE READING THE
ENGINE MANUAL PROVIDED IN THE PARTS PACKET.
ALWAYS WEAR A PROTECTIVE HEARING DEVICE.
IF AUGER ISMOUNTEDTO ENGINE,ALLSAFETYGUARDS
MUST BE SECURELY ON TO AVOID SERIOUS INJURY.
STARTER ROPE CAN CAUSE AN UNANTICIPATED JERK
TOWARDS ENGINE. PLEASE FOLLOW INSTRUCTIONS
TO AVOID INJURY.
IF ENGINE FAILS TO START AFTER PERFORMING THE
STARTING PROCEDURES, PLEASE CONTACT OUR
CUSTOMER SERVICE DEPARTMENT AT 800-345-6007.
NEVER LEAVEENGINE RUNNING WHILEUNATTENDED.
TURN OFF AFTER EVERY USE.
NEVER CARRY POWERHEAD AND AUGER BETWEEN
HOLES WHILE ENGINE IS RUNNING.
A
IMPORTANT
ENGINE CAN OVERHEAT AND BECOME DAMAGED
IF DEBRIS BLOCKS THE COOLING FINS OR RECOIL
HOUSING.
NEVER RUN
ENGINE WITHOUT COMPLETE AIR
CLEANER INSTALLED ON ENGINE.
10
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5