32 Degrees Rebel Panduan Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan paintball 32 Degrees Rebel. 32 Degrees Rebel 9 halaman.

Halaman Cetak

General Description and Basic Use Instructions

Included with your Rebel semi-auto should be the

following items:

• Rebel Semi-Auto

• Barrel

• Low Pressure Chamber

• Packet with o-rings, velocity thumb

screw, and allen wrench

• Separate Allen wrench

The 32 Degrees Rebel is almost ready to use out of the

box. All that is needed is a C02 tank, paintballs, and a

feeder, and then you are ready use your marker.

First screw in your barrel (hand tight). Now that your

barrel is in, insert the barrel plug into the front of the

barrel. With your barrel plug in, you are ready to work on

your marker. Next push the safety in the "safe" position

and attach your feeder elbow and feeder to the power

feed tube. Turn the power feed plug so that it does not

allow paintballs to enter the chamber. Screw the low

pressure chamber into the front end of the marker, just

below the barrel. Now that you have everything

connected you are ready to gas up the gun. Before you

gas up the marker you should always wear paintball

approved goggles.

Getting Started

maintenance

Now that the goggles are on make sure your marker is in

the cocked position. Install the C02 tank and your Rebel

is ready to fire. Make sure you chronograph your marker

before you use it. Like any other paint marker,

maintenance is the key to keeping the Rebel shooting

consistently. This chapter is a basic overview of what it

takes to keep the Rebel functioning properly.

Lubrication: To keep your Rebel's internal

components operating smoothly, place about four

drops of oil in your gun's C02 adapter and dry fire the

gun (after removing the barrel). This will spread the

oil throughout the gun. After cleaning your Rebel

internally, lube the hammer/push strut assembly as

well--be careful not to over-oil this area.

Warning: Some petroleum based oils can damage

your gun's o-rings. Use only oil manufactured

specifically for paintball markers.If you expect any degree

of consistency from your Rebel, you must keep it clean

internally and externally. The two external areas you'll

need to be the most careful with are the power feed/feed

tube and the barrel. If you break a ball in the barrel, you

will lose most of your accuracy until you clean it

completely. On the field, remove the barrel and run a

pull-through squeegee through it. For a more

complete cleaning (off the field) you'll need to clean

the barrel with warm water or barrel cleaner/treatment

and squeegee it until it is dry. A pull-through squeegee

can also be used to clean the power feed once the plug

is removed.