32 Degrees Rebel Xtreme Panduan Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan paintball 32 Degrees Rebel Xtreme. 32 Degrees Rebel Xtreme 9 halaman.

Halaman Cetak

General Description and Basic Use Instructions

Included with your Rebel Xtreme semi-auto should be the

following items:

• Rebel Xtreme Semi-Auto

• Barrel

• Low Pressure Chamber

• Packet with o-rings, velocity thumb

screw, and allen wrench

• Separate Allen wrench

The 32 Degrees Rebel Xtreme is almost ready to use out

of the box. All that is needed is a C02 tank, paintballs,

and a feeder, and then you are ready use your marker.

First screw in your barrel (hand tight). Now that your

barrel is in, insert the barrel plug into the front of the

barrel. With your barrel plug in, you are ready to work on

your marker. Next push the safety in the "safe" position

and attach your feeder elbow and feeder to the power

feed tube. Turn the power feed plug so that it does not

allow paintballs to enter the chamber. Screw the low

pressure chamber into the front end of the marker, just

below the barrel. Now that you have everything

connected you are ready to gas up the gun. Before you

gas up the marker you should always wear paintball

approved goggles.

Getting Started

maintenance

Now that the goggles are on make sure your marker is in

the cocked position. Install the C02 tank and your Rebel

Xtreme is ready to fire. Make sure you chronograph your

marker before you use it. Like any other paint marker,

maintenance is the key to keeping the Rebel Xtreme

shooting consistently. This chapter is a basic overview of

what it takes to keep the Rebel functioning properly.

Lubrication: To keep your Rebel Xtreme internal

components operating smoothly, place about four

drops of oil in your gun's C02 adapter and dry fire the

gun (after removing the barrel). This will spread the

oil throughout the gun. After cleaning your Rebel Xtreme

internally, lube the hammer/push strut assembly as

well--be careful not to over-oil this area.

Warning: Some petroleum based oils can damage

your gun's o-rings. Use only oil manufactured

specifically for paintball markers.If you expect any degree

of consistency from your Rebel Xtreme, you must keep it

clean internally and externally. The two external areas

you'll need to be the most careful with are the power

feed/feed tube and the barrel. If you break a ball in the

barrel, you will lose most of your accuracy until you clean

it completely. On the field, remove the barrel and run a

pull-through squeegee through it. For a more complete

cleaning (off the field) you'll need to clean the barrel

with warm water or barrel cleaner/treatment and

squeegee it until it is dry. A pull-through squeegee can

also be used to clean the power feed once the plug

is removed.