EarthQuake MiniMe P8 Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Pembicara EarthQuake MiniMe P8. EarthQuake MiniMe P8 16 halaman. Earthquake minime p8 subwoofer user's manual
Juga untuk EarthQuake MiniMe P8: Panduan Pengguna (8 halaman), Panduan Pengguna (16 halaman)
Halaman Cetak
(1) Volume Control
( )
2 50Hz - 160Hz
Frequency Adjustment
( ) 3 0-180° Phase Shift
(1) Volume Control
Manual volume control to regulate your subwoofers
power output, to prevent clipping and distortions
caused by overpowering.
(2) 50Hz - 160Hz
Frequency Adjustment
This controls the high frequency cutoff point. With the
control set to the middle, the subwoofer will reproduce
frequencies up to 105Hz. If the control is set fully
clockwise, the crossover is bypassed and the
subwoofer will reproduce a wide frequency range.
With the control fully counter-closkcwise the
subwoofer reproduces a narrow range, up to 50Hz.
Rotate the control until the bass sound natural. If the
mid-bass sounds natural but you want more low bass,
turn the control down a little.
(3) 0-180° Phase Shift
This control is used to acoustically match the
subwoofer's output to your main speakers. Select the
position, either 0° or 180°, in which your subwoofer
has more output at the listening position.
(4) Power Status LED
Earthquake powered subwoofers have an LED on the
panel that indicates the status of the built-in amplifier.
Earthquake • MiniMe User Manual
Control Panel Overview
Line Fuse
5
(4) Power Status LED
(5) Line Level RCA Inputs
(6) Sub Operation Switch
(7) Auto ON/OFF
(8) Speaker Level Inputs
(9) Speaker Level Outputs
(10) Manual ON/OFF Switch
(11) 110-120V AC Power Connection
The LED will light red when the amplifier is in standby
mode and green when the amplifier is on and
receiving a signal.
(5) Line Level RCA Inputs
Connect with RCA type patch cords to the line level
output of your receiver or pre-amp.
If your pre-amplifier or receiver has a single sub/LFE
output, connect it to the subwoofer's left input jack.
There is no need to use the subwoofers right input
jack. If you want to run your main/satellite speakers
full range, use a "Y" adapter at the pre-amplifier
outputs.
In this way, you can send the pre-amplifier's output
signal to your main amplifier and to the subwoofer at
the same time.
(6) Sub Operation Switch
In LFE position, the Frequency adjustment becomes
disabled and the subwoofer runs in a Full range
mode, from 20Hz - 2kHz.
While in Sub position the subwoofer reverts to the
manual frequency adjustment, allowing the user to
operate and fine tune the subwoofer to their personal
taste.