Award PPS902SI Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kap Ventilasi Award PPS902SI. Award PPS902SI 12 halaman.

Halaman Cetak

USE

Button Function

Turns the suction motor on and off at speed one.

Decreases the working speed.

Increases the working speed.

Activate intensive speed from any other speed,

including motor off. This speed is set to operate

for 6 minutes, after which the system returns to the

speed that was set before. Suitable to deal with

maximum levels of cooking fumes.

Press and hold the button for approximately 5

seconds, with all the loads turned off (Motor and

Lights), to turn the Activated Charcoal Filter

alarm On and Off.

24H function

Turns the suction motor on at speed one

and effects one 10 minutes extraction every hour.

When the filters alarm is triggered, the alarm can

be reset by pressing and holding this button for

approximately 3 seconds.

These indications are only visible when the motor

is turned off.

Delay function

Activate automatic switch-off with a 30' delay.

Suitable to complete elimination of residual

odours. Can be activated from any speed, and is

disabled by pressing the button or turning the

motor off.

Press and hold the button for approximately 5

seconds, with all the loads turned off (Motor and

Lights), to activate the Remote Control.

Turns the lighting system on and off at maximum

intensity.

Turns the Courtesy Lighting on and off.

Control panel

Display

Displays the set speed

Displays HI and the time remaining once every second.

FC+Dot (2 flashes)–Alarm On.

FC+Dot (1 flash)–Alarm Off.

Displays 24 and the dot at the bottom right flashes once

every second, while the motor is running.

It is disabled by pressing the button.

FF flashes three times.

When the procedure terminates, the indication shown

previously turns off:

FG indicates the need to wash the metal grease filters.

The alarm is triggered after the Hood has been in

operation for 100 working hours.

indicates the need to change the activated charcoal

filters, and also to wash the metal grease filters. The alarm

is triggered after the Hood has been in operation for 200

working hours.

Displays the operating speed and the dot at the bottom

right flashes once a second.

IR+Dot (2 flashes)–Alarm On.

IR+Dot (1 flash)–Alarm Off.