EarthStone pagw 110 Petunjuk Pemasangan, Pengoperasian, dan Pemeliharaan - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan, Pengoperasian, dan Pemeliharaan untuk Oven EarthStone pagw 110. EarthStone pagw 110 18 halaman. Gas fired oven
Juga untuk EarthStone pagw 110: Gambar Dimensi (2 halaman), Petunjuk Pemasangan, Pengoperasian, dan Pemeliharaan (17 halaman)

Halaman Cetak
EARTHSTONE OVENS PRE-ASSEMBLED GAS OVEN INSTALLATION INSTRUCTIONS – ETL LISTED
WARNING:
IMPROPER MAINTENANCE OF THIS APPLIANCE MAY RESULT IN A BUILDING FIRE OR PERSONAL INJURY.
DO NOT CLEAN OR SERVICE OVEN, HOOD OR VENT WHILE HOT OR WHILE OVEN IS IN OPERATION.
CONTACT THE FACTORY OR FACTORY REPRESENTATIVE OR A LOCAL SERVICE COMPANY TO PERFORM
MAINTENANCE AND REPAIRS.
1.
CLEAN OVEN REGULARLY WITH RECOMMENDATION CLEANING AGENTS AS NECESSARY.
2.
DISCONNECT POWER SUPPLY TO THE OVEN BEFORE CLEANING OR SERVICING.
3
TO REMOVE BURNER FOR CLEANING FOLLOW THESE STEPS:
DISCONNECT CABLE FROM SPARK IGNITER.
UNSCREW FITTING OF GAS SUPPLY LINE WHICH IS NEAREST TO BURNER ASSEMBLY THIS SUPPLY LINE
CONNECTS THE GAS VALVE TO BURNER ASSEMBLY.
TILT OPPOSITE END OF BURNER UP AND SLIDE BURNER DOWN FROM BURNER ENCLOSURE.
CLEAN BURNER WITH WIRE BRUSH TO ENSURE THAT ALL THE JET HOLES ARE CLEAN.
4.
TO REPLACE BURNER AFTER CLEANING FOLLOW THESE STEPS:
SLIDE BURNER INTO ENCLOSURE BY INSERTING END OPPOSITE TO GAS CONNECTION FIRST THEN THE
REMAINING OF THE BURNER UNTIL BURNER RESTS HORIZONTALLY IN BURNER ENCLOSURE.
CONNECT GAS SUPPLY LINE TO BURNER.
CONNECT CABLE TO SPARK IGNITER.
NOTE: ALWAYS CHECK FOR GAS LEAKS USING A SOAPY SOLUTION.

GAS BURNER MAINTENANCE

NEVER USE OPEN FLAME TO CHECK FOR GAS LEAKS
7