EarthWay 2130 Petunjuk Perakitan dan Pengoperasian

Jelajahi secara online atau unduh pdf Petunjuk Perakitan dan Pengoperasian untuk Penyebar EarthWay 2130. EarthWay 2130 4 halaman. High-output broadcast spreader
Juga untuk EarthWay 2130: Petunjuk Perakitan (5 halaman)

Halaman Cetak

2130

HIGH-OUTPUT B

ASSEMBLY and OPERATING INSTRUCTIONS

PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS

REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT

SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,

HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY

THIS SPREADER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE WHEELS, HANDLE ASSEMBLY AND

CONTROL ROD. IT SHOULD TAKE APPROXIMATELY 10 MINUTES WITH THE USE OF TWO 7/16" WRENCHES AND 1 PAIR

OF PLIERS.

; Clean the impeller plate after each use. Material stuck on the impeller blades will cause uneven spreading.

; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds

will change the spread patterns. Wet material will also change the spread pattern and flow rate.

; Clean your spreader thoroughly after each use. Wash between the shut off plate and bottom of the hopper.

; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.

; When using Rock Salt remove salt from the hopper daily. Rock Salt will reconstitute back into a solid block over night

with humidity. As a preventative measure, spray all metal parts thoroughly (inside the tubing too) with WD-40 to prevent

corrosion.

1. Open carton and remove the handle assembly, wheels, and

spreader from carton.

2. Turn spreader upside-down on to the hopper.

3. Ensure that the axle bearings are pushed into the axle bushing

on both sides as shown. Install drive wheel (both wheels are

interchangeable) to axle using pin hole nearest to lower handles as

shown. Insert 2" cotter pin through wheel and through axle. Bend

with pliers to prevent pin from falling out.

4. Install coast wheel to axle, then using outside pin hole as shown, insert 1" cotter pin

through axle (not thru the wheel). Bend with pliers to prevent pin from falling out.

roadcast

preader

techsupport

earthway

Lower

Handle

Frame

Brace

Coast Wheel

1" Cotter Pin

EarthWay



Rev. 3-10

SKYPE: EARTHWAY.TECH

com

Gearbox

Axle Assembly

Cross Brace

2" Cotter Pin

Pt# 53107

Drive Wheel

PAGE 1