ALLIGATOR sens.it RetroFIT-kit 2.0 Panduan Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Aksesori Mobil ALLIGATOR sens.it RetroFIT-kit 2.0. ALLIGATOR sens.it RetroFIT-kit 2.0 18 halaman. Pressure monitoring system
Halaman CetakDisplay commissioning
1.3 Insertion of the battery
Proceed as follows to open the battery compartment of the display:
In order to achieve the best possible adhesive effect, clean the back side of
the display so that it is completely free from dirt, silicone, wax, etc. (Figure 1)
Now remove the protective film on the self-adhesive side of the magnet
(Figure 2)
Centre the magnet on the back side of the display and press it gently on the
surface for about 30 seconds (Figure 3)
To open the battery compartment, turn the cover of the battery compartment
on the back side of the display unit anti-clockwise. (Figure 4)
Now take the button cell (battery) included in the scope of supply and insert it
in the display. (Figure 7) (When replacing the battery, please use an
equivalent button cell of the type CR2450).
Please observe the following when inserting the battery:
- There contacts must be free from dirt. (Figure 5)
- The contact points must not have any deformation (Figure 5)
- The battery must be inserted so that the + pole faces towards you (Figure
7)
- The seal (O-ring) must be present on insertion (Figure 8)
Gently press the cover in place. The cover must be positioned so that he
locking logs fit in the matching recesses on the back side of the display
housing. (Figure 6) Then turn the cover clockwise to lock. (Figure 9)
5