Christie Terra RXO 101 SO Panduan Pengaturan dan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengaturan dan Instalasi untuk Pengontrol Christie Terra RXO 101 SO. Christie Terra RXO 101 SO 17 halaman. Controlled systems

Halaman Cetak

Extension Setup

For proper ventilation and to prevent damage to the unit, ensure the wiring or other material does not obstruct the

air flow to or from the air vents.

1. Power off all equipment and install in a rack or set on a table.

2. Connect AV source to the DP IN (I) or HDMI IN (J) port on the TXO using a DisplayPort cable or HDMI

cable.

3. Optionally, connect a stereo analog audio source to the TXO (O) using an audio cable.

4. Connect the TXO and RXO using OM3 multimode 850nm fiber cable with duplex LC-LC connectors on

each end by inserting the cable into the SFP+ transceivers on the TXO (K) and RXO (10).

5. Connect an AV display to the HDMI OUT (9) port on the RXO using an HDMI cable.

Use the supplied HDMI Cable Lock to secure the HDMI cables to the TXO and RXO.

6. Optionally, to transport IR control commands between units, connect an IR receiver to the IR IN (Q or

16) port on the TXO or RXO near the remote control source; and connect an IR emitter to the IR OUT

(P or 15) port on the opposite (far) TXO or RXO that is near the device you want to control.

7. Optionally, make connections from the source USB connection to the USB (M) on the TXO and

connect a mouse and/or keyboard to the USB (12) on the RXO.

8. Supply power to the units by connecting the external power supply to the units (N and 13) and to a

power source. The power indicator on the TXO (A) and RXO (1) should light up. Green signal

indicators (C-E and 3-5, and optionally F and 6 for USB) light when a signal is present and

transported between the TXO and RXO.

If the source is not displayed, change the source signal that is transmitted (HDMI or DisplayPort) by pressing

the SWITCH (H) button on the TXO.

AV Processing Applications

The AV Processing application requires a 10G network switch and a Terra Controller. The Controller and

all TXs and RXs are connected to the same network.

Christie Terra Systems use a Terra Controller and a 10G network to configure, program, and control switching and

processing functions. This section contains quick start instructions using the Terra Startup Assistant application to start to

configure the system. For additional details, refer to the Terra User Manual (020-001355-nn).

http://bit.ly/TerraDownloads

Go to

Terra Controller Installation and Setup Manual

020-102804-02 Rev. 1 (09-2018)

for the current user documentation.

Install and Setup