Miele G 7825 Panduan Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin cuci Miele G 7825. Miele G 7825 44 halaman. Medium capacity glassware washer

Miele G 7825 Panduan Petunjuk Pengoperasian
Take care when handling liquids
such as detergents, neutralizing
agents, wetting agents and rinse aids.
These may contain irritant or corrosive
ingredients, acids or alkalis. Never use
any organic solvent, as the danger of
an explosion exists. Wear protective
gloves and goggles. The
manufacturer's safety conditions must
be observed at all times.
The water in the machine must not
be used as drinking water.
Be careful when sorting items with
sharp pointed ends. Position them
in the machine that you do not hurt
yourself or create danger for other
operators.
When using this machine regard
the high temperatures and be
especially careful not to scald or burn
yourself. When opening the door
bypassing the electrical lock, a danger
of burning, scalding or corrosion exists.
Let mobile units, inserts and cleaned
items cool before touching them. Any
water which may remain in containers
will be very hot and must be emptied
into the wash cabinet.
After drying with the TA drying unit
open the door to allow the items
and inserts to cool.
6
Do not touch the heating elements
(under the wide area filter) during
or directly after the end of a program,
you could burn yourself. They remain
hot for some time after the end of the
program.
If the boiler has been programmed
to "BOILER READY", be particularly
careful of hot water and steam when
opening the door. Danger of burning or
scalding. The water inlet pipe to the
wash cabinet is located, as viewed
from the unclean side, underneath the
basket runner on the left hand side.
Steam heating is permissible up to
a pressure of 145 psi. This
corresponds to a water steam
temperature of 179 °C.
Never clean the machine near or
with a water or high pressure hose.
Before servicing, disconnect the
power supply by either removing
the fuse, unplugging the unit or
manually "tripping" the circuit breaker.
,
Mount on non-combustible floor
only!