Miele PW 6101 Manual Petunjuk Pemrograman - Halaman 19
Jelajahi secara online atau unduh pdf Manual Petunjuk Pemrograman untuk Mesin cuci Miele PW 6101. Miele PW 6101 48 halaman. Profitronic m innovation m
Juga untuk Miele PW 6101: Panduan Petunjuk Pengoperasian (44 halaman), Panduan Petunjuk Pengoperasian (46 halaman), Manual Petunjuk Pemrograman (48 halaman)
Halaman Cetak
Peak load
With this option the programme is set up to
react to a peak load. If the input signal for a
peak load is detected and the programme is
in a heating phase the heaters will be
switched off and the programme stopped.
The following will then appear in the display:
Prog. stopped. Peak load cut-out.
If the programme is at thermo stop, then the
thermo stop safety time remains unaffected.
Create ~ Programme header
Peak load: Yes
Hot water control: No
-
e
Selection choice: - No - Yes
Hot water control
Create ~ Programme header
Hot water control: No
Price: No
-
e
Selection choice:
– No
– Yes
If hot water control is set to "Yes" the water
inlet valves will be programmed
automatically so that the required wash
temperature is achieved during the first
water intake by controlling the cold and hot
water inlet valves.
If the water valves are not set to automatic
the pre-selected water valves will be
controlled in conjunction with the hot water
control "Yes" irrespective of the required
temperature.
M.-Nr. 06 533 430
Price
By selecting the price option you can
allocate a specific cost to the programme.
This has to be paid before the programme
can be started.
Create ~ Programme header
Hot water control: No
Price: No
Selection choice: - No
-
If set to "No" the pricing message will not be
e
shown.
S
A
– 0.10 to 9999.90 in 0.10 increments
This concludes programming of the
programme header.
Pressing the S button will take you into
Block programming.
-
e
Modify ~ Block programming
S
A
Area: 1 Pre-wash
Block: 1
The following options can now be selected:
1 Pre-wash, 2 Main wash, 3 Rinses.
Modify ~ Block programming
Block: 1
Block parameter
This option is used for selecting:
Block 1 to 10 from the selected area.
After selecting block parameter you get into
the individual programme stages or the
selected block.
Programming
-
e
-
S
A
e
A
e
A
19