Miele PW 811 Rencana Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Rencana Instalasi untuk Mesin cuci Miele PW 811. Miele PW 811 38 halaman.

Installation and planning notes

Cold water

connection

Water connection

This appliance must be installed according to AS/NZS 3500.1. This

appliance has been supplied with a separate backflow prevention

device. This machine must be connected to the potable water

supply via the non-return valve (dual check valve) supplied with the

machine.

The water flow pressure must be at least 1 kPa and should not

exceed 1000 kPa. If it is exceeds 1000 kPa, a pressure reducing valve

must be used.

The machine must be connected to the water supply using the inlet

hoses provided.

 The connection points are subject to water supply pressure.

Turn on the tap slowly and check for leaks.

Correct the position of the washer and union if necessary.

Use the inlet hose supplied (cold - blue stripes) for the cold water

connection. For cold water connection, 2 x ¾" thread is required. If

there is only 1 cold water connection use the Y-piece supplied. If this

is not available, only a qualified installer may connect the washing

machine to the mains water supply.

The inlet hose for cold water (blue stripes) is not intended to be

used for a hot water connection.

If the hot or hard water connection is missing, cold water

consumption increases accordingly to account for the missing water

intake.

A non-return valve supplied separately with the machine must be

connected to the tap for both hot and cold water connection.

Install the dual check valve provided

between the water tap and Y-piece.

A Y-piece for connecting two inlet tubes to a single cold water line is supplied.

PW 811 / PW 814 / PW 818