Allmand Night-Lite E Series Panduan Operator - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Operator untuk Peralatan Pencahayaan Allmand Night-Lite E Series. Allmand Night-Lite E Series 20 halaman. Portable light tower

Halaman Cetak

WARNING

Burn Hazard

• Light fixtures become very hot dur-

ing operation and shortly after shut-

down.

• Handle hot components, such as

light fixtures, with heat resistant

gloves.

NOTICE

• Any part which is found defective as a

result of inspection or any part whose

measured value does not satisfy the

standard or limit MUST be replaced.

• Always tighten components to the

specified torque. Loose parts can

cause equipment damage or cause it

to operate improperly.

• The use of authorized replacement

Allmand parts is encouraged. The

warranty does not cover damage or

performance problems caused by the

use of parts that are not authorized

replacement parts.

• Clean all accumulated dirt and debris

away from the body of the equip-

ment and its components before you

inspect the equipment or perform

preventative maintenance procedures

or repairs. Operating equipment

with accumulated dirt and debris will

cause premature wear of equipment

components.

• Retrieve any tools or parts that may

have dropped inside of the equipment

to avoid improper equipment opera-

tion.

Safety Decals

Before operating your unit, read and

understand the following safety decals.

The cautions, warnings, and instruc-

tions are for your safety. To avoid

personal injury or damage to the unit,

understand and follow all the decals.

Keep the decals from becoming dirty or

torn, and replace them if they are lost

or damaged. Also, if a part needs to be

replaced that has a decal attached to

it, make sure to order the new part and

decal at the same time.

WARNING

If any safety or instructional decals

become worn or damaged, and can-

not be read, order replacement decals

from your dealer.

Compare Figure 1 with the table

following.

Figure 1