Miele G 1 Series Manual - Halaman 42

Jelajahi secara online atau unduh pdf Manual untuk Mesin pencuci piring Miele G 1 Series. Miele G 1 Series 46 halaman.
Juga untuk Miele G 1 Series: Manual (14 halaman)

Halaman Cetak

Technical Information

Function

Second interim rinse

SC (with or without

cutlery tray) - available

for ID no. -1856

Machine height setting

Country setting

Model setting

Table 27: Service Programming Mode, G 2732

This parameter can also be modified by the customer in the Settings menu under

External Water Softeners. See the appropriate operating/installation instructions. If the

dishwasher is connected to an external ion exchanger water softener (i.e. that needs to

be reactivated with salt), the sensor softener must be deactivated and the water

hardness must be set manually. If this value is unknown, 8°d should be set.

If the electronic needs to be replaced during servicing, then the following steps must be

taken during programming: Set the country variant, then switch off the machine. Access

the programming mode again and set the machine height.

The SER variant includes the following countries: Portugal, France, the Netherlands,

Belgium and Great Britain.

Save and quit:

Switch off the appliance.

2.12

LaPerla - G 283x/G 2872

Initial requirements:

1. Close the door (open for G 2872).

2. Switch off the appliance.

Accessing:

1. Press and hold the C (clear) button.

2. Switch on the appliance.

3. Release the C (clear) button when the display lights up.

4. Immediately press the C (clear) button 5 times; on the 5th time, hold for

at least 4 seconds.

Acknowledgement indicator:

The top line of the display shows Service programming.

The display always indicates three parameters at a time.

Programming

Select 2nd interim rinse.

Select a setting; confirm with

OK.

Select SC. Make a selection

and confirm with OK.

Select Appliance height.

Select a setting; confirm with

OK.

Select Country version.

Select a setting and confirm

with OK.

Select Model type. Select a

setting and confirm with OK.

G 1xxx/G 2xxx

Display

Options: On, Off (standard setting).

Options On, Off.

Programming function not available

at this time.

Options: Normal (G 1xxx),

XXL (G 2xxx).

Setting options: EUR (Europe),

AUS (Australia), USA, JPN (Japan),

I/E (Italy/Spain), SER (Southern

Europe).

On models with salt container in the

door (SIT) (G x73x), this option

must be set to 0.