Miele G 1202 Manual - Halaman 14

Jelajahi secara online atau unduh pdf Manual untuk Mesin pencuci piring Miele G 1202. Miele G 1202 14 halaman.
Juga untuk Miele G 1202: Manual (46 halaman)

Halaman Cetak
Technical Information
1.11

LaPerla - G 283x/G 2872

Initial requirements:
1. Close the door (open for G 2872).
2. Switch off the appliance.
Accessing:
1. Press and hold the C (clear) button.
2. Switch on the appliance.
3. Release the C (clear) button when the display lights up.
4. Immediately press the C (clear) button 3 times; on the 3rd time, hold for
at least 4 seconds.
Acknowledgement indicator:
The top line of the display shows Service program.
The display always indicates two or three parameters at a time, depending on model.
Options:
Function
Check ID. no.
Fault code display
Fault code deletion
Component test
Operating hours check
LED test
Buzzer test

Table 11: Service Mode Summary, G 283x/G 2872

Programming
Select ID number. To
return to the main menu,
press OK.
Select Fault memory. To
return to the main menu,
press OK.
Select Fault memory.
Select the option Delete
fault memory? with the
cursor buttons; confirm
with OK.
Select Component with
the cursor buttons.
Activation of the individual
components V01 - V18
takes place via the cursor
buttons. To return to the
main menu, press C
(clear).
Select Operating hours
with the cursor buttons. To
return to the main menu,
press OK.
Select Operation. Select
B01: LED test. To return
to the main menu, press
C (Clear).
Select Operation. Select
B02: Buzzer test. To
return to the main menu,
press C (Clear).
14
G 1xxx/G 2xxx
Display
The display shows the ID numbers
of the BAE (selection-display) and
SLT (control-power) electronics.
The display shows the saved fault
codes. If multiple fault codes have
been registered, they are all shown.
Alternatively, the message No fault
is displayed. See the service
manual for a list of fault codes.
In the display, the option Delete
fault memory? is shown along with
the saved fault codes.
The display lists the available
components and mini-program with
wiring diagram/short description.
The relevant test program starts
after 2 s (see the service manual).
The display shows the total
operating hours.
All LEDs and the display light up.
Buzzer on.