Miele G 1472 Manual - Halaman 8

Jelajahi secara online atau unduh pdf Manual untuk Mesin pencuci piring Miele G 1472. Miele G 1472 14 halaman.
Juga untuk Miele G 1472: Manual (46 halaman)

Halaman Cetak

1. Optima - G 1472/G 2472

Technical Information

5. Release the Program button.

6. If the "Rinse & Hold" LED does not light up, repeat the procedure.

Acknowledgement indicator:

The "Rinse & Hold" LED flashes slowly (1 flash per second).

Options:

Function

Software version ID check

Display and delete fault

memory

Component test

Operating hours check

LED test

Table 5: Service Mode Summary, G 1472/G 2472

1.6

Advanta - G 2020

Initial requirements:

1. Close the door.

2. Switch off the appliance.

3. Turn the selector switch to the 12 o'clock position.

Accessing:

1. Press and hold the Start/Stop button.

2. Switch on the appliance.

3. Release the Start/Stop button.

4. Immediately press the Start/Stop button 3 times; on the 3rd time, hold

Programming

Do not press the options

button. The "Tab" LED is

not lit.

Press the options button

once. The "Tab" LED

flashes once quickly

intermittently. Press the

Program button. Press it

again to display fault

codes that may have been

saved. To delete the fault

memory, press the

Program button again and

hold it for 4 s.

Press the options button

2x. The "Tab" LED flashes

2x quickly intermittently.

Press the Program

button. Press it again to

activate the next

component.

Press the options button

3x. The "Tab" LED flashes

3x quickly intermittently.

Press the options button

4x. The "Tab" LED flashes

4x quickly intermittently.

Press the Program button

once.

G 1xxx/G 2xxx

Display

The display shows the software

version ID no. in consecutive digits

(e.g., -818).

The display shows F and a fault

code number alternately (for a list of

fault codes, see the service

manual). If the fault memory is

empty, F and 0 are displayed

alternately. See the service manual

for a list of fault codes.

The display shows which

component is being tested. For

example, if drain pump M8 is being

tested, U and 3 are shown

alternately. For the test sequence

and background information about

individual components and their

activation, see the service manual.

The display shows the number

of operating hours as follows: If the

appliance has run for 74 hours, h, 7

and 4 are displayed alternately.

The display shows 6.1. All LEDs

light up.