Allmand MAXI LITE II Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Peralatan Industri Allmand MAXI LITE II. Allmand MAXI LITE II 17 halaman.

SERIAL NUMBER 10-000001 & 11-000001

** * Units with LSC modules (digital display screens/ Auto start) have a smaller

120 transformer that plugs into pin#16 of LSC. Check power from main breaker

all the way up to pin#16 for correct voltage.***

Lights fail to Illuminate.

❏ Check power at the main breaker. Power should be 120/240 from the gen to the main

breaker. If power is lower than recommended rating, check the capacitor and generator

output.

❏ If power is 120 at the main breaker, proceed to the light switched and light relays. Each

light breaker should have the same voltage at the main breaker (120/240) and current

should pass through each light relay. If voltage is found to drop then fix or replace the

breaker or the light relay.

❏ Power is tested good at both light and switches, ensuring ballast is receiving sufficient

voltage in ( @ 120/240). Power out of ballast to the capacitor and light circuit should

measure 360-440 volts (+/ - 10%) is within spec. * *If a voltage test yields high voltage

other than normal at lamp output to light then this is an indication that the

light/tower cord has a short (Example- 500-600 volts indicates backfeeding

through tower cord due to short in circuit).

Testing generator output at the GFCI receptacle:

W ARNING: Dangerous voltage and/or current may be present when a

voltage test is being conducted. To reduce the risk of serious injury or death from

electrical shock, if you are not trained to safely work with high voltage, do not attempt

any of these procedures. You must seek assistance from qualified personnel.

Generator output voltage may be tested by using a multimeter to measure the voltage

across the terminals of the GFCI power receptacle.

MAXI LITE II