Miele AWG 102 Panduan Pengoperasian dan Instalasi - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Instalasi untuk Kap Ventilasi Miele AWG 102. Miele AWG 102 24 halaman. External motor roof installation
Juga untuk Miele AWG 102: Petunjuk Pengoperasian dan Pemasangan (28 halaman), Panduan Petunjuk Instalasi (28 halaman), Panduan Petunjuk Instalasi (28 halaman)

The ducting stub on the motor unit has

a diameter of 125 mm when the

appliance is supplied.

^ If a diameter of 150 mm is required,

the front ring of the stub must be cut

off at the join with a sharp knife (see

illustration).

^ Remove the roofing around the

installation area.

^ Bend flashing a upwards.

^ Position the motor unit on the roof

with the air outlet directed down the

roof.

^ Secure the motor unit to the roof

substructure with fixing plate b.

^ Replace the roofing. Press down on

the flashing to ensure that it creates a

proper seal.

The flashing should be fitted under

the roofing at the top of the motor

and above the roofing at the sides

and the bottom of the motor.

^ Push the flexible vent ducting onto

the ducting stub on the motor unit

and secure it with a hose clip.

^ Connect the control cable plug

connectors.

^ Use the extension cable supplied to

extend the length of the connection

cable, if necessary.

Equipotential bonding is required if

the control cable is to be extended

by more than the extension cable

supplied (see "Electrical connection").

^ If required, connect the earth lead to

connection point c in the housing.

Important: When feeding the cable and

the exhaust ducting through the

substructure of the roof be careful to

ensure that any gaps are sealed

properly afterwards.

Installation