Burk PlusConnect GatesAir ZXA Panduan Instalasi dan Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pemancar Burk PlusConnect GatesAir ZXA. Burk PlusConnect GatesAir ZXA 13 halaman.

Halaman Cetak

Mapping additional channels is accomplished in AutoLoad Plus by selecting the Meter Channels,

Status Channels or Commands tab, as appropriate:

1. Within any of these tabs, click the Override button to change a channel's assignment from a

traditional I/O channel to a Plus-X channel.

2. When the Override Channel dialog appears, select Plus-X channel and choose the Plus-X

device from the list.

3. Select the PlusConnect channel you wish to use in place of this I/O channel.

4. Click OK.

Once mapped, the PlusConnect channel will appear on the front panel of the ARC Plus, in AutoPilot, on

the ARC Plus web page, and will be accessible via the ESI/RSI.

Setting up Labels, Limits and Alarms

Labels, limits and alarms for PlusConnect parameters are set up in AutoLoad Plus. The process is the

same as for limits and alarms of other ARC Plus channels. Refer to the ARC Plus manual for information

on channel configuration.

Important! Because operation preferences vary so widely, no alarms are pre-configured within the

PlusConnect channels. You must use AutoLoad Plus to set up alarms for the PlusConnect channels.

Creating a PlusConnect Custom View in AutoPilot Plus

The easiest way to monitor your PlusConnect parameters is by creating a Custom View in AutoPilot

using a pre-built template specific to your transmitter model. In order to use templates, you must map

the default set of channels to the ARC Plus during setup. If you have mapped a custom set of channels,

you can still use a Custom View to display them, but the template will not function as intended.

PlusConnect™ GatesAir ZXA Installation and Operation Manual

PlusConnect Custom View for the GatesAir ZXA