ALLNIC AUDIO T-1800 MK2 Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat ALLNIC AUDIO T-1800 MK2. ALLNIC AUDIO T-1800 MK2 13 halaman. El34 stereo integrated amplifier

Halaman Cetak

SPEAKER TERMINALS

The T-1800 MK2 is equipped with two pairs of high-quality speaker terminals. These terminals are located at the left

of the back of the chassis (the right, facing the front of the chassis). Facing the front of the chassis, the right channel

pair is on the outside right and the left channel pair is to their left, on the other side of the impedance toggle. The

terminals accept bare wire (not recommended) and spade and banana type connectors. Please refer to Figure 2.

POWER CONNECTION

Connect the input interconnects and/or the speaker cables or the Pre-Out connections before you insert the

power cable into the receptacle at the centre of the chassis rear. The T-1800 MK2 uses a standard three prong

male IEC connection for AC input. You need to use a power cord with a female three prong IEC connector at one

end. Please refer to Figure 2.

The T-1800 MK2 will be set internally for your location's electrical system characteristics. Please check

the setting for electrical input on the label on the rear of the unit to confirm that your T-1800 MK2

matches your location's electrical system. For North American customers, the T-1800 MK2 is set

internally for AC 110/120 volt – 50/60 Hz. For customers in other regions, the unit is set for 230/240V

– 50/60 Hz operation. There is no way to change to another AC setting.

INITIAL POWER-ON

Once you have your T-1800 MK2 in place and all connections have been made to your turntable and preamplifier,

you are ready to turn on the power for your T-1800 MK2; before you power it up, though, be sure you have:

•

removed ALL protective cushioning material (cardboard around the tubes) inside the tube chimneys

before operation. The tube chimneys should contain NOTHING except the tubes

"O" rings on the small tubes; some prefer the sound with the O rings on.)

•

checked that power tubes are snug in their sockets (this is essential)

•

ensured the interconnects are firmly attached

•

turned the preamplifier's and T-1800 MK2's volume controls down to zero (if you use that combination) and

otherwise zeroed or muted the volume on your source(s)

• ensured the batteries are in the remote control – if not, insert the batteries (by removing plate on the

bottom of the remote control)

• securely and correctly fastened the speaker cables and ensured that they are also connected properly to the

speakers.

Turn on the T-1800 MK2 by pushing in the power switch button located at the front of the right-side chassis panel to

the "on" position (See Figure 3). After about a thirty to forty (30 - 40) second delay (the soft start), the T-1800 MK2

will be powered on.

OPERATION - CHASSIS AND REMOTE CONTROL

When the power is on, the current meters on the face of the chassis will illuminate. From this point on, the T-1800

MK2's operation is straight-forward. The face of the chassis has an input selector control knob and a volume control

knob (see Figure 1). The remote control (Figure 4) will also control the input selections (using the number buttons or

the buttons labelled "CH") and the volume. However, it will not control the power to the T-1800 MK2, which must

be switched on and off manually, as described above. The power button on the remote control, at its top left-hand

(It is optional to leave the