DIAL CASS-PNL-18-24-36 Panduan Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kipas angin DIAL CASS-PNL-18-24-36. DIAL CASS-PNL-18-24-36 4 halaman. For cassette panel

Halaman Cetak

If the long screws are tightened insufficiently, it may cause of the failure.

Air Leakage

Smudge

Dewing

When there is still the gap even after tightening the long screws firmly

enough, readjust the height of the indoor unit.

No gap shall exist.

Do not turn the air louver by hand.

If moved

the louver mechanism would be damaged

NOTE

*For cassette （cooling capacity＞18000Btu/h ） supporting panels：

The indoor unit height can be adjustable by using the wrench from the

corner pocket.

Wrench

*Signifcant height adjustment will cause of dewing from the drain pan .

Louver

2.4 Wiring Connection for Air Panel

The wiring connector is located at the panel as shown in the figure.

Display Board

Wiring

(On the Panel Side)

(10-Pole Connector)

Pull out the wiring connector, and then connect it with the

connector on the unit.

The wiring connect with control board please refer to INDOOR WIRING

DIAGRAM .

Before electrical wiring work

If the connectors are connected without turning OFF the power

source

the auto

swing louver can not activate

After completing the wiring connection of the panel ,fix the

motor wiring for the auto louver with the fixing hooks firmly.

Then attach the air intake grille in the reverse procedure for

installation .

Protect the wires or etc. from rats or other animals.

If not protected, rats may gnaw at unprotected parts and at the

worst, a fire will occur.

3.Test Run

After indoor and outdoor runs,

Please press "swing'' button when operate louvers by using remote

controller, details see remote controller manual.

Never move the swing louver by hand.

Motor Wiring for Auto Louver

(On the Panel Side)

(5-Pole Connector)

wiring

turn OFF the power source

check the swing louvers.

VERSION NO.1545617,C