Allo RemoteControl NICE HSRE12 Petunjuk

Jelajahi secara online atau unduh pdf Petunjuk untuk Penerima Allo RemoteControl NICE HSRE12. Allo RemoteControl NICE HSRE12 3 halaman.

INSTRUCTIONS

NICE HSRE12

To enable the control devices to activate the outputs of HSRE12, the device codes

must be memorised on the receiver.

Memorising devices on the HSRE12 receiver:

To memorise a device, proceed as follows:

01.Press S1 (PROG) to activate programming mode; a BEEP indicates the start of

programming;

02. Select the required output by pressing S2 repeatedly (SEL.CAN); the relative led

of the ALL output illuminates;

03. Memorise one or more devices for each output, performing the action specified in

Table 1;

Visit our Website. www.alloremotecontrol.com

04. A BEEP confirms correct programming, 3 BEEPS indicate that the device has

already been memorised;

05. To memorise other devices on other outputs, repeat points 02 and 03;

06. The memorisation phase terminates by pressing S1 and S2 simultaneously or after

1 minute of inactivity.

Caution! It is not possible to memorise devices with a timed function

together with devices with an ON-OFF function on the same output.

Visit our website: www.Alloremotecontrol.com

families: