ABB ACH580-01 Series Petunjuk Manual - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Peralatan Industri ABB ACH580-01 Series. ABB ACH580-01 Series 8 halaman. Base drive replacement
Juga untuk ABB ACH580-01 Series: Manual (16 halaman), Panduan Instalasi dan Start-Up Cepat (17 halaman), Petunjuk Manual (7 halaman), Panduan Instalasi dan Start-Up Cepat (17 halaman), Panduan Instalasi dan Start-Up Cepat (17 halaman)

REPLACEMENT INSTRUCTIONS | ACH580-01 BXR UL TYPE 1 & 12, R1/R2

Step

Instruction

Cut zip tie

by pulling out the terminal block.

NOTE: Remove any additional drive I/O wiring.

Using a PZ2 bit, loosen and remove wires from the Input Terminals

of the drive.

Using a PZ2 bit, loosen and remove wires from the Motor Terminals

of the drive.

Using a PZ3 bit, loosen and remove ground wire from the drive.

Using a T20 bit, loosen and remove six (6) screws securing the

flange plate

Save hardware.

and remove the CDPI

from drive. Set aside.

and disconnect the RS485 cable

Diagram

from the drive