Dialog DA16200 Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat Keras Komputer Dialog DA16200. Dialog DA16200 20 halaman. At gui tool

DA16200 AT GUI Tool

3.5

OTP Mode Setup

To enable OTP mode, check on OTP Enable option on the OTP Mode tab then the current OTP data

will be shown in

Figure

26.

●

Power calibration and temperature calibration has been completed for the chipset by FCI and

it may not need to be done by the customer.

●

Freq Offset cal

The range of frequency offset calibration is 0x0 ~ 0x7F.

●

MAC Address setup

DA16200 provides 4 slots to store MAC addresses and the 1st slot is written by FCI. The customer

can use 3 slots to write their own MAC address. The MAC address written in the OTP must be an

even number, it is used for WLAN0 MAC address (for STA interface), and the next number is

automatically used for WLAN1 MAC address (for Soft-AP interface).

To write the MAC address, give a MAC address in the first empty slot and click the Write button then

the new address substitutes for the previous address.

User Manual

CFR0012

Revision 1.0 DRAFT

16 of 20

03-Jul-2019