Alloy LED PrimaLine Neon 100 SB Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Peralatan Pencahayaan Alloy LED PrimaLine Neon 100 SB. Alloy LED PrimaLine Neon 100 SB 5 halaman. 24v led tape light

Halaman Cetak

NOTE: The images on pages 2-5 show PrimaLine Neon 100 SB. For PrimaLine Neon 200 TB, follow the same instructions, but

note that the tape light PCB inside of the silicone is rotated 90°, with the diodes pointed toward the diffuser.

CUTTING TAPE LIGHT

1. Cut the tape light to the desired length using the black indicator that can be seen on the side of the tape light

through the silicone casing. We recommend using a Multi-Angle Miter Hand Shear for a clean and precise cut.

Cut on Black Indicator

NOTE: Dark indicator can be seen through the silicone casing.

USING DIY CONNECTORS AND END CAPS

1. Connect the tape light to power using the DIY connectors. To

assemble the DIY connector:

a) Slide the rubber washer onto the prongs of the connector. Make sure to

align the rubber washer so it sits against the plastic protrusion on the

connector, without a gap.

b) Thread the plastic cover onto the PrimaLine Neon Tape Light where

the tape light will connect to power. Make sure that the grooves on the

inside the plastic cover are aligned with the indentations on the sides

of the tape light. (Continued on next page)

www.AlloyLED.com

page 2 of 5

Installation Instructions

Plastic Cover

Rubber Washer

Metal Clamp

Call: 800.910.LEDS [5337]

Specifications subject to change without notice.

NOTE: Avoid twisting or any harsh movement that may damage

the internal components.

Silicone Insert

PrimaLine Neon Tape Light

Silicone Insert

Metal Sleeve

Text: 510.400.6690

LED

IP65

Notches

Indentations

[email protected]