ABB ACS880-31 Panduan Instalasi dan Start-Up Cepat - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Start-Up Cepat untuk Peralatan Industri ABB ACS880-31. ABB ACS880-31 17 halaman. Converter modules with electrolytic dc capacitors in the dc link
Juga untuk ABB ACS880-31: Manual (16 halaman)

ABB ACS880-31 Panduan Instalasi dan Start-Up Cepat
6.
Connect the power cables. For the tightening torques, refer to
Ground the shield 360 degrees by tightening the clamp of the power cable grounding shelf onto the stripped part of
the cable (6a).
Connect the twisted shield of the cable shields to the grounding terminals (6b).
Frame R8: If needed, install the common mode filter. For instructions, see
Connect the phase conductors of the motor cable to the T1/U, T2/V and T3/W terminals. Connect the phase
conductors of the input power cable to the L1, L2 and L3 terminals (6c).
If the DC cables are present, cut off one phase conductor and isolate the end. Connect the remaining conductors to
the UDC+ and UDC- terminals.
Tighten the screws to the torque given in the installation drawing below.
R3
1.7 N·m
L1, L2, L3, T1/U, T2/V, T3/W, UDC+, UDC-:
1.7 N·m (15 lbf·in)
R6
2 N·m
L1, L2, L3, T1/U, T2/V, T3/W, UDC+, UDC-:
15 N·m (11 lbf·ft)
1.7 N·m
6a
1.7 N·m
(15 lbf·in)
2.9 N·m
6b
2.9 N·m
6a
(2.1 lbf·ft)
.
Terminal data
Related
6c
6b
6c
L1
L2
L3
documents.
1.7 N·m
2.9 N·m
6