ALLpaQ Packaging Group Genesis 250 Panduan Pengguna Operator - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna Operator untuk Peralatan pengemasan ALLpaQ Packaging Group Genesis 250. ALLpaQ Packaging Group Genesis 250 13 halaman.
Halaman Cetak
1.3 Fitting port position plates to bag
ALLpaQ recommend that all 3D bags used in conjunction with it bioprocess range of containers
should be fitted with a small plastic support disc when filled. Some bags may be pre fitted with a
similar disc however if this is not the case please contact ALLpaQ immediately before use.
To fit the disc simply squeeze the tubing (Fig 3.1) and slide towards the centre of the disc as
shown (Fig 3.2).
1.4 Fitting the bag
When fitting a bag the operator can access the base of the container over the erected side panels
(Fig 4.1).
The bag can be located from this position.
Fig 4.1
Fig 4.2
Bag filling can commence, according to manufacturers recommendations.
ALLpaQ recommend foam dunnage for all shipping containers (see 2:4 Fig 4.5)
Fig 3.1
Fig 4.3
Fig 4.4
Fig 4.5
Manual V1 - (Sept 14
Fig 3.2
Please ensure that the clamp on the
outlet tube is closed/open prior to
operation according to manufacturers
instruction. (Fig 4.3)
Feed the outlet tubing through the
drain hole in the base of the
container (Fig 4.1).
It may be helpful to pull the tubing by
accessing the chamber via the front
door on the base of the unit (Fig 4.4).
Once the tubing has been fed
through, the white disc will locate in
the bottom drain hole of the base
unit (Fig 4.2).
The end of the drain tubing should
be fitted to the tube clamp for easy
access (Fig 4.5)
th
2012)