Allpax SM4 Panduan Petunjuk Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemotong Allpax SM4. Allpax SM4 12 halaman. Allen rotary-style gasket cutter

Halaman Cetak

OPERATING THE UNIT

(Figure 4) Unscrew and remove the scale bar knurled nut from the

scale bar assembly.

NOTE: The SM4 scale bar knurled nut incorporates a

left-hand thread.

Using the guide hole, position the gasket material onto the threaded

scale bar spindle. Screw the knurled nut back onto the spindle to firmly

secure the material. Hand tighten.

(Figure 6) To cut the OD, engage the top cutting disc by rotating

the cutting disc lever clockwise. The top cutting disc should now pen-

etrate or contact the gasket material and is now in the proper position

for cutting.

(Figure 7) Turn the hand crank clockwise. Simultaneously, with

the other hand, maintain a constant downward pressure on the cutting

disc lever. As the cutting discs rotate, the gasket material will be drawn

towards the cutting discs initiating the cutting process. Continue crank-

ing until the entire OD of the gasket material has been cut. Disengage

the top cutting disc. Discard unwanted material.

NOTE: Cutting thick and/or tough materials may require

more than one revolution through the unit. Flipping the

material over and repeating the above process is often

advantageous.

(Figure 8) To cut the inner diameter (ID), loosen the scale bar

T-screw, and slide the scale bar to the desired setting. Hand tighten

the scale bar T-screw. Engage the top cutting disc. Turn the hand

crank, simultaneously maintaining downwards pressure on the cutting

disc lever as before. Continue cranking until the entire ID of the gasket

material has been cut. Disengage the top cutting disc and remove the

newly cut gasket. Unscrew and remove knurled nut from spindle.

Discard unwanted material.

(Figure 9) To cut irregular shaped gaskets, mark the shape desired

on the gasket material with a pencil or pen. Loosen the scale bar

T-screw. Remove the scale bar, and manually feed the material through

the cutters while operating the unit in the same manner as above.

An additional set of hands may be needed to guide material.