AllPondSolutions 500-HO+ Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Sistem Penyaringan Air AllPondSolutions 500-HO+. AllPondSolutions 500-HO+ 17 halaman. Aquarium hang-on filter with uv

Halaman Cetak
Remove the filter from the box. Wash the floss filter pad and filter foam with
water from your tank. Important - do not use mains water or any cleaning
products to clean your filter media.
Additional filter media to add into the media baskets not included.
Insert the telescopic pipe and inlet tube into the filter body. Ensure that all
connections are clicked into place as far as they will go. (image 1, 2)
Position the filter in your aquarium, ensuring that the water level is high
enough to submerge all inlet points and piping connections. Ensure that the
surface skimmer is positioned below the water level, allowing it to collect
surface debris and avoid air intake into the unit. (image 3)
Place the floss filter pad, filter foam and your filter media baskets into your
media holder and insert into the filter body. (image 4)
Adjust the balance plate so that your filter is level in your aquarium, sitting in
a vertical position. (image 5)
Fill the filter body with tank water to allow the unit to prime efficiently. To
6
avoid priming problems, ensure water level is high enough to submerge ALL
inlet points and piping connections. Switch on the unit. (image 6)
Rotate the top flow rate adjuster to increase or decrease the water intake
7
from the filter body. For the initial start-up and to prime the filter more
quickly, rotate the flow rate adjuster to maximum. Once priming has been
completed, you can re-adjust the water flow rate to your desired output
level. (image 7)
Rotate the side flow rate adjuster to increase or decrease the water intake
8
from the surface skimmer. (image 8)
Switch on the UV steriliser at the back of the filter body. (image 9)
9
Once switched on, the UV indicator light on the top of the filter body will be
10
lit. (image 10)
Once operating, the water will enter the unit via the inlet tube until the
system is fully primed and exit via the waterfall outlet. (image 11)