AllPondSolutions EF2+ Manual - Halaman 5
Jelajahi secara online atau unduh pdf Manual untuk Akuarium AllPondSolutions EF2+. AllPondSolutions EF2+ 20 halaman. Aquarium external filters
Unpack the unit and identify all parts using the parts diagram in this manual.
1. Attach the EF tap to the filter head, pull up the tap handle to allow insertion (1), push
the tap into the head tap area (2), fasten the tap into place using the tap handle (3).
2. Unclamp all four head and body clips and separate the filter head from the filter
body.
3. Take out the filter media secure plate and pull out the filter media baskets using the
handles provided. Using the baskets, rinse your filter media under the tap until it runs clear.
Once you have done this you should place the rinsed baskets and filter media back
inside the filter with the filter media secure plate at the top. Before replacing the motor
head on the filter, fill your filter 3/4 full with water from your aquarium.
4. Place the motor head back on top of the unit.
5. Shut both of the motor head levers down and fasten the buckles to the side of the
filter.
6. Check that the EF tap is shut to avoid leakage (lever down), and ensure your pipework
is setup as per the Set Up Diagram
Fit your hose to your aquarium so as the inlet hose is fitted to the overflow pipe and the
outlet hose is fitted to the spray bar as per the Set Up Diagram. Please ensure your
aquarium water level is high enough to cover all inlet and outlet pipework connection
points, as otherwise you can let air into the filter system which will stop it from priming
properly.
You may need to cut off any excess hosing to ensure the hose is not slack or causes
looping. Ensure that the hose follows a straight line from the canister to your aquarium and
its intake connection point is approximately 7.5cm (3 inches) below the water line. It is
advisable to allow a small surplus before cutting the hose – you can always cut the hose
further during final installation. This is extremely important as if the hose is too long, the
filter may not operate correctly.
– the 'cut' side of the hose must always be connected to the inlet and outlet
IMPORTANT!
pipework connection points, NOT to the inlet / outlet tap hose adapters. The cut end of
the hosing must also be kept underwater to ensure a watertight seal.