Dialogic D/4PCI Instalasi dan Penggantian - Halaman 6
Jelajahi secara online atau unduh pdf Instalasi dan Penggantian untuk Kartu PCI Dialogic D/4PCI. Dialogic D/4PCI 18 halaman. Linecard
Juga untuk Dialogic D/4PCI: Instalasi dan Penggantian (19 halaman)
Halaman Cetak
Dialogic D/4PCI Linecard Installation and Replacement
Installing the D4/PCI Linecard in the Platform
Since Dialogic D/4PCI linecards are designed to be installed in the PCI expansion bus,
the interrupt requests and memory addresses used by the cards are assigned by the BIOS
of the platform, not by configuring jumpers or switches. All PCI linecards installed in the
platform should share IRQ 5. The method of assigning this interrupt will vary depending
on the particular BIOS and platform used. For example, a BIOS may allow you to assign
IRQ 5 to the PCI expansion slots you intend to use for the linecards. Another BIOS may
automatically assign IRQ 5 to the PCI expansion slot based on its location in the
platform. Refer to the platform documentation to determine how to configure the
platform to assign IRQ 5 to expansion slots used by PCI linecards.
After you have prepared the Dialogic PCI linecards for installation and have determined
how to assign IRQ 5 to the expansion slots they use, you can install the linecard in the
computer platform.
Dialogic D/4PCI linecards cannot be used with any other makes or models of
telephony linecards. If other makes or models of telephony linecards are installed
in the platform, they must be removed prior to installing D/4PCI linecards.
To install D/4PCI linecards:
1. If possible, configure the Dialogic System Service to start manually.
If Dialogic System Software is...
Installed on the platform
Not installed on the platform
2. From the Start menu, point to Programs, point to Dialogic System Software, and
select Dialogic Configuration Manager – DCM.
6
IMPORTANT
Then...
Continue to step 2.
Skip to step 5.
ã
R2A
September 2000 Ericsson Business Networks AB