AllPondSolutions AqueECO 8000 Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Pompa Kolam AllPondSolutions AqueECO 8000. AllPondSolutions AqueECO 8000 14 halaman.

To ensure your new pond pump is set up and running correctly, and to prevent

any accidental damage or injury, please read and follow the below instructions

carefully before using your product.

SAFETY

IMPORTANT!

Disconnect the mains electricity supply before attempting any

installation / maintenance of any kind. Do not attempt to modify this unit in

any way and only use the recommended parts for replacement.

The AquaECO pond pump should never be run dry as this will cause the

unit to overheat and cause permanent damage.

All connections must be earthed.

The power cord of this appliance cannot be replaced; if the cord is

damaged, the appliance should be discarded. Never cut the cord.

Do not connect to any voltage other than that stated.

Do not place in liquids other than water.

Do not use with water above 90 F or 30 C.

Do not carry or pull the unit by its electrical cable.

Do not use this unit if it has a damaged cord, if it is malfunctioning or it is

dropped or damaged in any manner

Do not attempt to modify this unit in any way and only use attachments and

the recommended parts for replacement recommended by the

manufacturer.

Before installing, maintaining or handling your equipment, or before placing

your hands in your pond, ensure that the unit is disconnected from the

electricity supply.

Always disconnect any electrical devices when not in use.

To avoid injury, do not touch hot or moving parts such as, but not limited to

UV bulbs or impellers.

During maintenance ensure all O-rings are present and intact.