Dialogic SCbus Instalasi

Jelajahi secara online atau unduh pdf Instalasi untuk Adaptor Dialogic SCbus. Dialogic SCbus 2 halaman. Eicon networks ctbus/scbus adapter installation

Halaman Cetak

Dialogic

CTbus/SCbus Adapter

Installation

The Dialogic

CTbus/SCbus Adapter is used to interconnect

Dialogic

CTbus boards with Dialogic

same chassis. Only one adapter is required per system.

Before You Begin

Protect Yourself from Electric Shock

The CTbus carries electrical signals. To reduce the risk

of electric shock:

Switch off the power and remove power cords

before opening the PC cover.

Do not re-attach power cords and switch on power

to the PC while the PC cover is removed.

Protect the Board from Damage

Protect the Board from Static Electricity

CAUTION: All computer boards are sensitive to

electrostatic discharge ("ESD"). Handle all static-

sensitive boards and components at a static-safe work

area, and observe anti-static precautions at all times.

If you are not familiar with ESD safety precautions, visit

http://www.dialogic.com/support/hwinstall

Part Number

64-0010-02

Unpack the Dialogic

according to the following steps:

Dialogic Corporation.

Note: Place the adapter in static-shielding bags when carrying

it from station to station.

CAUTION: Do not remove the adapter from the anti-

static packaging until you are ready to install it.

Observe proper anti-static precautions at all times.

Installing the CTbus/SCbus Adapter

Before installing the CTbus/SCbus Adapter, ensure that the

SCbus boards in the

Dialogic

order. The board on which the adapter will be installed must

be inserted in the first PCI slot adjacent to the ISA slot (Figure

1).

To install the Dialogic

Locate the board that will be used to connect the

CTbus/SCbus Adapter. It will be the card inserted in the

first PCI slot adjacent to the ISA slot.

Align pin 1 of the CTbus/SCbus Adapter with pin 1 of the

edge connector on the board (Figure 2). NOTE: Edge

connector is not labeled.

to learn more.

Unpacking the Board

CTbus/SCbus Adapter ("adapter")

Prepare a static-safeguarded work area.

Carefully remove the adapter from the shipping

carton and the anti-static packaging. Handle the

adapter by the edges and avoid touching the

components.

Lay the adapter on the static-dissipative work

surface.

boards in your chassis are positioned in the correct

Figure 1. Board Order

CTbus/SCbus Adapter:

Figure 2. Adapter Alignment (D/41ESC-PCI shown)

Press the CTbus/SCbus Adapter to the board (Figure 3).

Figure 3. Connect the Adapter (D/41ESC-PCI shown)

Connect the CTbus and SCbus cables as per the

installation instructions for your Dialogic

board(s).